Intellinet GuestGate HotSpot Gateway Manual do Utilizador descarregar pdf (Página 22)

- 22 -

Click on START -> RUN

Type in: cmd

Press Enter.

At the DOS Command prompt type: ipconfig/all and press Enter.

Example Output:

The PHYSICAL ADDRESS is the MAC Address which needs to be entered in the

configuration of GuestGate.

The format is: xx:xx:xx:xx:xx:xx

(not xx-xx-xx-xx-xx-xx)

3. Access Control: Welcome Screen

Welcome Screen

Enable or disable the welcome page for guests. (Default = enabled.) If this parameter

is set to “disabled”, all guest users can access the Internet freely. No welcome page is

displayed, even if a guest password is defined below.

Guest Password

If you require your guests to enter a password to access the Internet, you can define it

here. If left empty, no password is required (default = no password). This is the global

password that can be used by any guest; it is not an individual user password. The

password option is only active, if the Welcome Screen is set to “enabled” (see above).

Access Control: Welcome Passwords

Set up individual user passwords that are only valid for a certain time period and can

be used by a defined number of computers simultaneously. The example below shows

a password “test” that is valid from “03/12/2009, 12 pm” until “03/13/2009, 6 pm”. The

password can be used by five users simultaneously.

Up to nine users can use the same password. The amount of user passwords is

limited by available memory in GuestGate, but should ideally not exceed 20.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 40 41

Sem comentários

Intellinet GuestGate HotSpot Gateway Manual do Utilizador Página 22